B3730 Ginetta G25 OBD Code

OBD/2 B3730 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

B3730 Ginetta G25 Error Code Repair Process :

The rule of B3730 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of pressure control solenoid c intermittent short. Likewise, overriding the OBD B3730 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Ginetta G25 B3730 OBD2 Code

A common cause of code B3730 is the failure of Pressure Control Solenoid C Intermittent Short, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Engine Control Module (ECM)
Failures of clutch motion/travel sensors.
Continuous oil flow to the VCT piston chamber

B3730 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B3730 Ginetta G25 OBD Code

B3730 Ginetta G25 Error Code Repair Process :

Common Causes of Ginetta G25 B3730 OBD2 Code

B3730 code for other Ginetta cars