B298A Packard Custom OBD Code

OBD/2 B298A error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

B298A Packard Custom Error Code Repair Process :

If your vehicle failed a B298A test and the B298A Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 20-50

Common Causes of Packard Custom B298A OBD2 Code

A common cause of code B298A is the failure of , but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Engine Control Module (ECM)
• Fuel tank leaking
• Faulty Crankshaft Position Sensor (POS)

B298A is a kind of Body Trouble Code Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

B298A code for other Packard cars

You can view according B298A DTC for your car model. We selected several models to see obd2 solutions click and view it.

• B298A Packard 12
• B298A Packard 120
• B298A Packard 200
• B298A Packard 300
• B298A Packard 400
• B298A Packard 7
• B298A Packard A
• B298A Packard Carribean
• B298A Packard Cavalier
• B298A Packard Clipper
• B298A Packard De
• B298A Packard Eight
• B298A Packard Executive
• B298A Packard Mayfair
• B298A Packard Patrician
• B298A Packard Super
• B298A Packard Twelve
• B298A Packard Twin

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved