B2951 Buick 2430 OBD Code

OBD/2 B2951 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

B2951 Buick 2430 Error Code Repair Process :

The rule of B2951 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of exhaust pressure control valve intermittent. Likewise, overriding the OBD B2951 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Buick 2430 B2951 OBD2 Code

A common cause of code B2951 is the failure of Exhaust Pressure Control Valve Intermittent, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Faulty TCM or TCM programming
Exhaust tube
Intake Valve Timing Control Solenoid Valve harness is open or shorted

B2951 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B2951 Buick 2430 OBD Code

B2951 Buick 2430 Error Code Repair Process :

Common Causes of Buick 2430 B2951 OBD2 Code

B2951 code for other Buick cars