B2382 Opel Corsa E OBD Code

OBD/2 B2382 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

B2382 Opel Corsa E Error Code Repair Process :

The rule of B2382 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of air suspension front inflator solenoid output circuit open. Likewise, overriding the OBD B2382 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Opel Corsa E B2382 OBD2 Code

A common cause of code B2382 is the failure of Air Suspension Front Inflator Solenoid Output Circuit Open, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Erratic camshaft position due to low oil pressure
Clogged or faulty fuel injector (s)
Failures of clutch motion/travel sensors.

B2382 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B2382 Opel Corsa E OBD Code

B2382 Opel Corsa E Error Code Repair Process :

Common Causes of Opel Corsa E B2382 OBD2 Code

B2382 code for other Opel cars