Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
The rule of B2178 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of b2178 window driver rear remote down switch short to battery. Likewise, overriding the OBD B2178 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
Difficulty Level (Easy)
|
Repair Time (20 Min.)
|
Cost Prediction : $ 60-110 |
B2178 is a kind of Body Trouble Code
Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems. |
You can view according B2178 DTC for your car model. We selected several models to see obd2 solutions click and view it.