The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke). The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.
If your aux heater glow plug circuit open check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system B204E and engine control unit are in charge of monitoring a bunch of different aux heater glow plug circuit open, and if they get a reading that's a little out of whack, up pops the check engine light.
Difficulty Level (Expert)
|
Repair Time (60 Min.)
|
Cost Prediction : $ 80-120 |
B204E is a kind of Body Trouble Code
Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems. |
You can view according B204E DTC for your car model. We selected several models to see obd2 solutions click and view it.