B1736 Trouble Code

View B1736 obd/2 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code B1736, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code B1736 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

Difficulty Level (Soso)

Repair Time (50 Min.)

Cost Prediction : $ 30-110

B1736 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine B1736 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If b1736 mirror driver vertical switch circuit short to ground so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the b1736 mirror driver vertical switch circuit short to ground.

B1736 is a kind of Body Trouble Code Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Common Causes of B1736

A common cause of code B1736 is the failure of B1736 Mirror Driver Vertical Switch Circuit Short To Ground, but there are several other possible causes as well, such as ;

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Exhaust tube
• Improper ignition timing
• Faulty Variable Camshaft Timing (VCT) position solenoid

B1736 code for all cars

You can view according B1736 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+B1736 Radical Sr3

+B1736 Lotus Eclat

+B1736 Mercedes-benz 350

+B1736 Land Rover Series Iii

+B1736 Mercury El Gato

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved