B1654 Nissan Pulsar OBD Code

OBD/2 B1654 error code description and symptoms.

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value. Low fuel pressure Damaged FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

B1654 Nissan Pulsar Error Code Repair Process :

The rule of B1654 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of b1654 seat driver recline backward circuit short to ground. Likewise, overriding the OBD B1654 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Nissan Pulsar B1654 OBD2 Code

A common cause of code B1654 is the failure of B1654 Seat Driver Recline Backward Circuit Short To Ground, but there are several other possible causes as well, such as ;

Erratic camshaft position due to low oil pressure
Erratic camshaft position due to low oil pressure
Faulty TCM or TCM programming
Variable Camshaft Timing solenoid stuck open

B1654 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B1654 Nissan Pulsar OBD Code

B1654 Nissan Pulsar Error Code Repair Process :

Common Causes of Nissan Pulsar B1654 OBD2 Code

B1654 code for other Nissan cars