B0335 Caterham 485r OBD Code

OBD/2 B0335 error code description and symptoms.

The Transmission Fluid Pressure Switch allows the engine's control module (PCM) or Transmission Control Module (TCM) to use hydraulic fluid to engage the clutches in the transmission to allow for smoother shifting while driving. If the PCM or TCM detects an issue with the hydraulic clutch or the pressure switch, the PCM or TCM will set code B0335

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

B0335 Caterham 485r Error Code Repair Process :

If your vehicle failed a B0335 test and the B0335 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses transmission fluid temperature sensor circuit high input a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look transmission fluid temperature sensor circuit high input: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Soso)

Repair Time (50 Min.)

Cost Prediction : $ 20-50

Common Causes of Caterham 485r B0335 OBD2 Code

A common cause of code B0335 is the failure of Transmission Fluid Temperature Sensor Circuit High Input, but there are several other possible causes as well, such as ;

• Continuous oil flow to the VCT piston chamber
• Camshaft Position Sensor harness is open or shorted
• Faulty oil control valve (OCV)
• Faulty Fuel injector

B0335 is a kind of Body Trouble Code Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

B0335 code for other Caterham cars

You can view according B0335 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• B0335 Caterham 120 Superlight
• B0335 Caterham 1700
• B0335 Caterham 21
• B0335 Caterham 275s-sv
• B0335 Caterham 7
• B0335 Caterham Beaulieu
• B0335 Caterham C
• B0335 Caterham R300
• B0335 Caterham Roadsport
• B0335 Caterham Seven
• B0335 Caterham Seven S3
• B0335 Caterham Super
• B0335 Caterham Super 7
• B0335 Caterham Superlight
• B0335 Caterham Superseven
• B0335 Caterham Vx

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved