U2358 Alfa Romeo 1900 OBD Code

OBD/2 U2358 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U2358 Alfa Romeo 1900 Error Code Repair Process :

If your abs inlet valve coil rr circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2358 and engine control unit are in charge of monitoring a bunch of different abs inlet valve coil rr circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Difficulty Level (Soso)
Level
Repair Time (30 Min.)
Time
Cost Prediction : $ 80-120

Common Causes of Alfa Romeo 1900 U2358 OBD2 Code

A common cause of code U2358 is the failure of ABS Inlet Valve Coil RR Circuit Failure, but there are several other possible causes as well, such as ;
Wrench Tool U2358 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U2358 code for other Alfa cars

You can view according U2358 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved