P2483 Mitsubishi Sigma OBD Code

OBD/2 P2483 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P2483 Mitsubishi Sigma Error Code Repair Process :

If your p2483 exhaust gas temperature sensor circuit range/performance bank 1 sensor 5 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2483 and engine control unit are in charge of monitoring a bunch of different p2483 exhaust gas temperature sensor circuit range/performance bank 1 sensor 5, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mitsubishi Sigma P2483 OBD2 Code

A common cause of code P2483 is the failure of P2483 Exhaust Gas Temperature Sensor Circuit Range/Performance Bank 1 Sensor 5, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty Intake Valve Timing Control Solenoid Valve
Faulty ignition coil (s)
Open or short in the VCT circuit

P2483 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2483 Mitsubishi Sigma OBD Code

P2483 Mitsubishi Sigma Error Code Repair Process :

Common Causes of Mitsubishi Sigma P2483 OBD2 Code

P2483 code for other Mitsubishi cars