DF214 Talbot 105 OBD Code

OBD/2 DF214 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Circuit High Input codes like DF214 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

DF214 Talbot 105 Error Code Repair Process :

The rule of DF214 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of scp (j1850) invalid or missing data for primary id / vehicle speed. Likewise, overriding the OBD DF214 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Talbot 105 DF214 OBD2 Code

A common cause of code DF214 is the failure of SCP (J1850) Invalid or Missing Data for Primary Id / Vehicle Speed, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
1Camshaft Position Sensor circuit poor electrical connection
Fuel pressure
Continuous oil flow to the VCT piston chamber

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

DF214 Talbot 105 OBD Code

DF214 Talbot 105 Error Code Repair Process :

Common Causes of Talbot 105 DF214 OBD2 Code

DF214 code for other Talbot cars