B2630 Peugeot 908 OBD Code

OBD/2 B2630 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

B2630 Peugeot 908 Error Code Repair Process :

The scent may B2630 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such B2630, so if the inside of your car scp (j1850) invalid or missing data for electric defrost as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Peugeot 908 B2630 OBD2 Code

A common cause of code B2630 is the failure of SCP (J1850) Invalid or Missing Data for Electric Defrost, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Fuel injectors harness is open or shorted
Incorrect Positive Crankcase Ventilation (PCV) hose connection

B2630 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B2630 Peugeot 908 OBD Code

B2630 Peugeot 908 Error Code Repair Process :

Common Causes of Peugeot 908 B2630 OBD2 Code

B2630 code for other Peugeot cars